2. analog
  3. 1372636562

Need advice: Turntable Output Voltage

Hello,

I am getting into vinyl and I need some help with my current stereo system, mostly with understanding the specs.

I have a Yahama RX-V1600 AV Receiver with a built-in phono pre-amp. The Input Sensitivity for the PHONO stage in the Yamaha is 3.5mV/47kOhms. The maximum input is 60mV or more, according to the user manual. I hooked up a Technics SL-QD33 turntable to the receiver. The Technics has an output voltage of 2.5mV at 1 kHz, with a recommended load impedence of 47kOhm~100kOhms. I am using a Grado Black cartridge with 5mV output, I believe.

Anyways, the turntable playback is rather quiet. I literally have to crank it up to get to reasonable listening levels. This may be a total noob question, but is the Technics output too low for the Yamaha receiver's phono stage?

I understand Phono is typically quieter than digital sources (for reasons we do not need to go into), but what do I need to do to get this analog system thumping? I do not think the Yamaha's phono pre-amp is faulty. I have hooked up an external Cambridge Audio phono pre-amp to the system as well, and it is still pretty quiet.

I was thinking about upping the "volume trim" on the Phono input by 6 db to see if this pumps up the volume some, although it may just make it even out relative to other input sources. Also, I am concerned that the volume trim may just amplify low-level noise/hiss.

Everything in the system is connected correctly and the turntable is grounded to the receiver.

Any advice would be much appreciated.

Thanks.
zdkaiser

Showing 2 responses by jjrenman

jjrenman
279 posts
 
"I dont understand what you mean by pumping up your phono input by 6db?"

Many of the newer AVR's have an input trim so that one can eliminate large differences in volumes when switching between inputs.
jjrenman
279 posts
 
TT don't have output unless they have a built in phono pre. Since your Yamaha has a built in phono than you will turn off the phono pre in the TT as you can use only one phono pre at a time. I suspect that you have already done that as you are not complaining of distorted sound or an extremely bass heavy playback. It is not uncommon for the phono to be 1/8 or 1/4 turn lower than your other sources. Your options are to turn it up however much farther you need to or use your phono trim to better even out the volume differences. As long as you can reach full volume before reaching about 2 O'clock on the dial there is no problem with having to turn the dial a bit farther for phono.

As far as noise goes, IME the noise increase will be the same between using the trim of 6db or just turning the VC up more to get the same 6db of increase.

Grado's have plenty of output so you should not be dealing with any hiss issues however Grado's do pick up hum more than other cartridges.
More to discover