2. amps-preamps
  3. 1351205787

MX 110 Troubleshooting

I recently purchased a Mcintosh mx110 z series tube preamp and am having a problem with one of the channels.
Left channel has very low and then no volume when I turn the amp on. If I turn the on-off switch on and off; sometimes the sound comes back on the left channel when the switch is in off position. Then it may stay working for 20 minutes or so before it fades to no volume again.
Not sure what type of problem this could be.

Any help would be appreciated.
nikef5s
6 responses Add your response
nikef5s OP
2 posts
 
Ok
So I finished cleaning switches and pots for second time.

Wow !

I have a beautiful fully functioning tube pre-amp!

Thank you
hifigeek1
770 posts
 
It's caustic so remove it before it eats into the chassis.
nikef5s OP
2 posts
 
Thank you all.

I cleaned switches and pots this cleared 85% of problems.
Tomorrow I will give it another round of cleaning.
Looked over the circuit assembly and see just a small spot of dark goo on the bottom of one of the capacitors.
rrog
1,958 posts
 
Start with the simplest thing first. Try cleaning all switches, buttons, etc before doing anything else.
mcintech
128 posts
 
Clean the pots and switches, especially the volume pot. My vintage gear has your exact symptoms when they need cleaning. With power OFF, spray pots and switches with NON residue electronic contact cleaner and exercise the switches and knobs for several minutes each, then spray again to remove contaminates loosened by the switch wipers.
brf
1,715 posts
 
Sounds like the caps are starting to fail.
Log in to respond
More to discover
80x80
Audio Research Reference Phono 3SE
80x80
Audio Mirror Wave
80x80
Ayon Audio Epsilon EVO Mono Amps Pure Class A
BEST OF SHOW 8 YEARS