musical subwoofer recommendation for 2-ch


Can someone recommend good subwoofers for 2-ch listening? I recently purchased a pair of very articulate speakers made by JAS audio. They have small woofers and so they are fast but do not have sufficient low bass.

I have a 15" Velodyne SPL-1500R. It is very powerful. But it is too slow to match up these speakers. So I'll save it for HT applications.

I am thinking to get two 10" subwoofers and connect them to the speakers. Is this a good idea? What are the good subwoofers I should consider?

Thanks in advance.
vett93
My Velodyne is getting much better after I use the high level inputs connected directly to the speakers and set the cross-over at its lowest value, 40Hz. This is the recommended approach of REL subs.

I noticed a higher distortion level when I played louder. I probably have reached the max output and the self protection circuit has kicked in.

Velodyne's website showed that SPL-1500R is too small for my house. The listening area is open to the rest of the house, which is about 8 times the size of the listening area. So I am thinking to get a 2nd subwoofer. My requirement wish list for this 2nd subwoofer has:

1. It should work well with SPL-1500R.
2. It should also be musical.
3. It should take both speaker-level and LFE inputs. Velodyne SPL-1500R can only take either one, but not both.
4. It should has separate gain controls for speaker-level and LEF inputs.
5. This is not a must. But ideally, it should have classical music and movie modes.

Which subwoofer will meet the above requirements?

My current sub is located along the long side wall. Should I put it at the corner to boost up the bass without clipping the amp or triggering the self protection circuitry?
Although I haven't compared 2 subs at the same time, my rel strata III works well with my magnepan 1.6's, which isn't a easy feat. A sub that is to be mated with magnepans has to be as tight and fast like the maggies. The fact that the strata III is sealed and has many tone controls allows it to blend quite nicely. I do have a question though concerning my rel. Does anyone know if the power switch on the REL Strata III should flicker when on? On mine the toggle switch for the power button which lights up, also flickers. Could this be a connection problem or is this common? Thanks.
I use a Velodyne HGS-15 with a pair of biwired KEF 102/2s crossed at 80 Hz, and they seem to blend seamlessly.

db
Post removed