What is the volume level setting when you crank it up and notice the strain? The XA-25 (same amp used in the INT-25) was tested by Stereophile at 80Wpc into 8 ohms and 130Wpc into 4 ohms. It does switch to class A/B at higher power output levels, so perhaps you are hearing that change?
I'm using the Pass INT-25 with Sonus Faber Electa Amator III speakers, 87db, 4 ohm, probably a more difficult speaker to drive than your Harbeths. With my chair at about 8 feet from the speakers I usually set the volume in the range of 40 to 50 depending on the CD (63 is the max volume). I've also wondered if a higher power amp might drive these speakers better, although I don't think I'd want to give up the INT-25 for moderate listening levels.
I'm using the Pass INT-25 with Sonus Faber Electa Amator III speakers, 87db, 4 ohm, probably a more difficult speaker to drive than your Harbeths. With my chair at about 8 feet from the speakers I usually set the volume in the range of 40 to 50 depending on the CD (63 is the max volume). I've also wondered if a higher power amp might drive these speakers better, although I don't think I'd want to give up the INT-25 for moderate listening levels.