2. cables
  3. 1140641366

Mixing speaker cable for Bass & Treble

Hi, I have recently acquired some Audioquest Midnight + speaker cables which I would like re-terminated into a bi-wire configuration. However, a friend has suggested leaving the cables as they are and using them for the bass and getting a separate pair for the treble. I know other 'goner's have used these with the Audioquest Sterlings and Argents, but I was wondering if they would work with other makes, like say, the Audience AU24's? Any advice/experiences would be welcome, thanks.
lt346mp

Showing 1 response by bgrazman

bgrazman
226 posts
 
I echo 240zracer's comments.

I use Nordost SPM's full range on my Gallo Ref. III's and add Wegrezyn Copper Slams (8 awg) for the second voice coil/sub. I was using my Nordosts for both (they are terminated for bi-amp/bi-wire), but for fun threw some old MIT MH 770's in and heard a big difference. This started my quest for speaker cables that performed well on bass (in my case, <50 Hz)... there is not a lot of information out there.

Good luck,
More to discover