Mid-Fi Amp/Preamp for Martin Logans

I would prefer SS rather than tubes but am open to either.

Thanks again!

I had ML Aerius, and would advise using at least a tubed amp, fussy as they can be. Not sure what your definition of "mid-fi" is... the ML's are not mid-fi. Try a VTL Stereo 80 or similar amp which provides at least 40 watts/channel.
For pre, you can go solid state; I used an audio research LS-3 with great results. Also used a tube preamp, a Counterpoint 3000--very dimensional with the Aerius...
Enjoy. -Ed

If your definition of "mid-fi" means cost below,say, $2000 for H/T separates, consider Sherwood Newcastle 9080 series (although the new 9090AVP pre will be out this fall).I'm using the 9080 with Magnepans all around with good results and I'm familiar with Martin Logan equipment.

If it would fit your budget, I would recommend an Innersound ESL amplifier for Martin-Logans, or any electrostatic speaker. It is made specifically for the capacitive load of an ESL, and drives them with ease, providing control and great dynamics, with no distortion. It is rated at 300 watts/channel into 8 ohms, and 600 into 4 ohms, with lots of current. This is an amp that will drive the M-L's to their full potential, and once you nail down this synergistic amp/speaker combination, it will allow you to really hear what the front end components are contributing, and make your choices there easier. Current Audiogon price is around $1700 for this amp. I personally would recommend a tube preamp for the dynamics and realism that it can provide. Possibly a pre-owned B.A.T. VK-3i, or a Sonic Frontiers SL-1 would work for you; I think they both have a H-T "pass through" feature, making them suitable for dual use.

My budget is $2k/total or less for the amp/preamp. I am trying to avoid the upper cost of the equipment spectrum (i.e., Mark Levinson or Red Rose). By no means, was I implying that the MartinLogans were mid-fi.

I'm using a Odyssey Stratos(www.odysseyaudio.com)$1100. with the cap upgrade paired with a used Rogue 66 tube pre that I picked up for $850.(www.rogueaudio.com). This combo makes beautiful sound! I'd recommend you go with a ss amp and a tubed pre. This is my first tube pre with a ss amp and I love it! Good luck and keep us posted.

Brad, which Martin Logans are you running off the Odyssey Stratos? I actually had considered this particular amp, and emailed Klaus yesterday but haven't heard back yet.

Also, are you using this for 2-channel or home A/V? Thanks!

At your price range I can recommend for HT and 2 channel,to go for either ADCOM or B&K,very decent sound at that price.Or you can get a Conrad Johnson for 2 channel like the MF-200 MOSFET power for your 2 channel and use the ADCOM 5 channel for HT and it would still keep you under 2 Gs.CHEERS.

Take a look at Quad. An amazing number of posters on the old Harbeth User's Site use them with the $6K Harbeth H40, which is kind of hard to drive. Quad also makes wonderful electrostats themselves, so they should work well. There are some great values in the used market here for Quad gear. BTW, all of them, (including R.E. Greene of TAS,) use the solid state versions. I use the Creek 5350SE in my system, but have been thinking of the Quad gear hard as they have pre amps with available tone "steps" to aid in those "not so great" recordings. Good luck. Charlie