MFA Luminescence MC Reference preamp


I'm curious about this preamp. Any opinion on this very unique octal tube preamp would be wonderful.
128x128mikelakers
Hello fellow audio-nuts. While you have most of the facts right, you've got some of them wrong. There was a preamp from MFA called "Luminescence" (I have two. One early pre-production A and a heavily moded B1), with various versions (A, B, C etc). There was a "Venusian", and an "MC Reference", both of which were NOT Luminescences. Lumi was the only one to my knowledge to use octal base tubes, and was dropped only for the reason of unavailability of inexpensive low-noise octal bases for the phono. MC Reference was actually a hybrid (technically speaking) design with heavy solid state regulation. Very rare and expensive in $5k range for a used one. Venusian I've never heard nor seen but I don't believe it used octal bases, I may be wrong here, but it was definitely not called a "Luminescence Venusian". Thanks for the forum, Mark
A question for kana813: do you have any pictures/schematics for Venusian? How was it broken down into three chassis? And BTW, I agree that you have to search hard to find a better phono (or line for that matter) than a Lumi. Recapping with modern colder and more open caps (MIT, InfiniCaps etc.) make a lot of difference too. I tried most everything including Loesch and still stuck with a Lumi. Phono section is a little noisy for MC cartridges but... Thanks, Mark
The "Venusian' is, as far as I know, the origins of the Lumi. I apparently bought a earlier near proto unit that was hand wired (as if any of them wern't!)

It uses a 40-45kb dual mono solid state PS box, which is fully stuffed. Four transformers, about 5 chokes.

A separate box for the phono section. It is fully stuffed. With boards and binding posts, with "Randall Research" wire. The same wire that was in the original Mod Squad line Drive. It uses 4 5691's, and two 6em7's. It has a second set of RCA jacks to load the given cartridge separately from the stock 47k ohms.

The upper, line stage box uses 2 6SN7's and 2 6DN7's. And a pair of 12AU7's for tape line out buffers. Everything but the volume control is activated as single channels. Two overall 'gain steppers (5 steps) and an overall ladder discrete type 23 step volume control.

Three Chassis total.

It rocks! As you might imagine.

Here comes the painful part: I got mine off Ebay for $106.05. Fuuken A! It was so badly represented, that no-one recognized it. But I'd recognize a Bruce Moore circuit and wiring..anywhere. I knew what it was. Seven sweaty days of waiting later..it was mine. I went looking for 'broken tube amps'..and stumbled across it.

one last point: Scott Frankland (the F in MFA) still works on these, for those who want them modded out properly.