Kevint: Do you mean placing the marble between the floor and the stands? I have found a general belief in the forums that stands need to match the type of floor that they are used on. Heavy massive stands for floors that have very little give (such as slab floors) and rigid but lighter stands for floors that have more spring or give to them. I have used both types of stands on a floor (heavy plaster cement type material) that has very little give to it and found the first type of stand to offer superior sound. I started off with light rigid stands and did try placing marble between the floor (resting on top of the carpet and rug) and the bottom spikes of the stands. This setup made the system sound thin and bright. I tried it out with two different amps (ss and tube) and two sets of speakers (Castle Isis and Renaud Twins). I did not try spiking the marble to the floor though. I also tried the marble between the top plate of the stand and the speaker with a substance similar to Blue Tack as coupling on both sides of the marble (I did not try spikes). This setup sounded better than the first go round, but not good to my ear. Now that I have heavy massive stands I may give both setups another try. I still wonder if spiking the marble to the floor would be an improvement, but just do not have the materials available to try it out, plus the spikes would have to be affixed to the marble for safety and stability issues. Also the marble that I used is only 1" thick and I beleive that it is called shystic (sp) marble which is not at all pure in its makeup. If you try any of the combinations out I will be interested in the results that you achieve. The marble that I used was given to my wife's girlfriend for her patio. I have another 4' piece of the marble, but need to have it cut to size (we just want a pastry board cut from it and the remaining portion will be enough to try on the new stands and speakers). If it doesn't work I will just place my wife's orchids on the pieces. I doubt if I will get around to it anytime soon though.
Marble to place speakers on?
I remember reading a thread pertaining to placing your speakers on a marble surface. Up to this point I have been unable to find this thread on the audiogon site. So I am going to ask the question again. What should the demensions of my marble be? Height, Width, Depth, and Thickness. I appreciate your time.