2. speakers
  3. 127271-88935

Magnepans

I'm kinda new to the plannar/magnepan world, but I am really interested in trying out a pair after all the reviews I've been reading. From what I understand these speakers are quite power hungry. What is the minimum I need to properly drive these? 
I currently have a VAC Avatar integrated tube amp. These are the stats:
Type: Integrated vacuum tube amplifier with MM phono stage and home theater (direct power amplifier) mode.
Tube Complement: two 12AX7 low noise (phono), two 12AX7 (line stage), three 12AU7/6189A (power amplifier), and four EL34 (power amplifier)
Options: Remote control for volume (motorized direct control) & mute
Power amplifier ("Home Theater" direct mode):
Output matching: 4 or 8 ohms nominal
Power output: 60 watts/channel ultra-linear; 27 watts/channel triode
Frequency response: 9 Hz - 35 kHz +0 / -0.5 dB, 3 Hz - 71 kHz +0 / -3.0 dB
Power bandwidth: 11 Hz - 63 kHz + 0 / -3.0 db ref. 50 watts
Gain: 25 dB ultra-linear; 23 dB triode
Residual noise: 1.5 mv at 8 ohm output
Channel separation: -72 dB @ 1 kHz; -60 dB @ 10 kHz
Line stage preamplifier:
Gain: 24 dB
Maximum input signal: Infinite (attenuation precedes line stage)
Noise contribution: Approx. 0.1 mv at power amplifier output 
THD contribution: Approx. 0.04% 
Tape output: Unity gain from selector, non-inverting 
Phono stage preamplifier: 
Gain: 37 dB (measured at tape output)
MC phono stage in place of the MM optional 
Residual noise: 3 mv at output (S/N ratio approx. 69 dB) 
Overload: 117 mv @ 1 kHz = 8 volts RMS output, 460 mv @ 10 kHz 
Frequency response: RIAA +/- 0.25 dB 
Notes: Does not invert absolute phase. 

Anyone know if these will do or if I'll have to upgrade? Love the tube sound . . . will I need to go solid state for Maggies? Thanks for putting up with the noobie question :) 
the_nature_boy

Showing 1 response by drbarney1

drbarney1's avatar
drbarney1
187 posts
 
If you have a tube amplifier and you need power to drive Magnepans, and you know how to do it, replace the output transformer of your tube amplifier with a headphone amp stepped down to about 800 Ohms, for SET the LL1930 is perfect for this. Connect the 800 Ohm secondary between the grid of an 833A triode and ground. The 833A works this way with zero grid bias. Connect one side of the tungsten cathode to ground too and heat the cathode with 10 Volts at 10 Amps well filtered DC. Run this at a modest 1000 Volts on the plate through a Hammond 1642SE transformer and use the 4 Ohm taps on the secondary for the Magnepans. That will be more than enough power and it will not strain. I tried it and it and it is the best
i ever heard.
More to discover