I have had good luck with an Anthem MCA-2 series 1 for a mere $400. Gives you 200 watts at 8ohms or of course more for the 4ohm maggies. I have had good luck with Rotel amps too, but the Anthem was better with the mmg's.
The FIRST thing you should do is take off the panel on the back and wire out the fuse with a soldering iron--you may want to wait until after the 60 days as it will void the return policy. The fuse is there to blow if the speaker is driven at high volumes for a long period of time to prevent the voice coil wire from getting too hot and melting though the milar film. I have had maggies for 8 years and never blew a REALLY enhances the imaging. I have removed the fuses on my MMG's, SMGa's, and MG-III's with no problems.
Also, crossover upgrades on the mmg's make a big difference. I replaced the caps with Multicaps for $18 each. Great improvement and easy. I also replaced the inductors with air core units. This was harder, but also valuable. My experience with replacing crossover components on my MG-III's suggests replacing the inductors should be done with the caps.
These are good suggestions for upgrades once you decide to keep them. I think the MMG's are an astonishingly good speaker for the money, particularly if you buy them used and spend the $175 on crossover upgrades.
The FIRST thing you should do is take off the panel on the back and wire out the fuse with a soldering iron--you may want to wait until after the 60 days as it will void the return policy. The fuse is there to blow if the speaker is driven at high volumes for a long period of time to prevent the voice coil wire from getting too hot and melting though the milar film. I have had maggies for 8 years and never blew a REALLY enhances the imaging. I have removed the fuses on my MMG's, SMGa's, and MG-III's with no problems.
Also, crossover upgrades on the mmg's make a big difference. I replaced the caps with Multicaps for $18 each. Great improvement and easy. I also replaced the inductors with air core units. This was harder, but also valuable. My experience with replacing crossover components on my MG-III's suggests replacing the inductors should be done with the caps.
These are good suggestions for upgrades once you decide to keep them. I think the MMG's are an astonishingly good speaker for the money, particularly if you buy them used and spend the $175 on crossover upgrades.