2. pc-audio
  3. 118940-388

MAC Book Pro Computer vs Aurender N100h vs Aurender N10 Music Servers

I am considering replacing my MAC Book Pro Computer with the Aurender N100h music server. The N100h has received great reviews, has quality construction, provides Tidal support and offers the convenience of using an iPad. My local dealer "highly recommends" I consider the Aurender N10 music server OVER the Aurender N100h server. He feels the N10 would sound much better than my current MAC Book Pro Commuter or the N100h. He said the N100h would only be marginal better than my MAC Book Pro. To be honest, I was really considering the N100h because of its sound quality, construction and my budget.

However, based on the reviews, etc., I am sure the Aurender N10 sounds great but it costs $8,000 (expensive). I found one N100h review that said “ ….Not one single combination of Mac Mini & peripheral devices has so far bested the sound of Aurender’s N100H; a digital audio streamer/server that comes pre-loaded with: 1) audiophile-approved 120Gb solid state hard drive (for cached playback); 2) custom 35 Watt linear power supply; 3) low noise USB output. Check one, check two, check three”.

This is probably not a fair comparison since the N10 cost is $8k and the N100h cost is $3k. What are your comments about replacing my MAC Book Pro Computer with either the N10 or the N100h? Has anyone replaced their MAC Book Pro with one of these Aurender servers?

And, yes, I plan on visiting my local store shortly to hear both the N10 and the N100h. My current MAC Book Pro computer is connected to my Bricasti M1 DAC connected to my Hypex NCore NC400 Bridged mono blocks class D power amplifiers and my Sonus Faber Olympic II Speakers.   The 4 NC400 power amplifiers (2 amps per side) were modified (4 R141 chips removed) to match to the volume control in the Bricasti M1 DAC (running DAC direct to amp, no pre-amplifier).   Thanks.

hgeifman

Showing 1 response by shadorne

shadorne's avatar
shadorne
7,477 posts
 
BIT-Perfect means that properly working equipment and set up should sound the same irrespective of the source of the file. This is a FACT. It is supposed to sound the same as that is the whole point of high-FIDELITY!

If it doesn’t sound identical then something is wrong with the equipment. It is as simple as that. Something that is perfectly the same as in “bit-perfect” MUST sound identical if equipment is excellent and working properly.

Of course there is a lot of bad equipment out there and identical files may not sound the same due to the poor way they are transmitted, decoded and converted.

So get things straight: The cause of identical files not sounding the same is BAD quality equipment (or firmware or software or incompatibilities)! 


More to discover