Lovan: Stereophile recommended disappointment.

How about a Heli-coil thread repair kit? Can be found at most auto and hardware stores. I don't TWEAK, I POOGE
POOGE = Progressive/Optimization/Of/Generic/Equipment.
Its a under ground movement which take much more heat than tweakers do. We would love to have a guy like you in are organization I'll even give you the secret hand shake. Can you tell me where I can get info on T4?

I have to agree with the Lovan assessment...

I believe I purchased the same rack Kal is speaking of(Pyramid). I use it for my fiance's system. It was bought at an unbelievable sale, way less than 50% of retail. It seemed that Lovan was doing that a lot last year.

I was astonished to see the poor construction, ala the AWFUL alignment of the legs. Plumb they are not. Nor even close. The rack IS usable, but I do expect a rack that retails for $650 - $700 to fit together. The spikes do not come close to lining up with the impressions they are supposed to fit into.

As mentioned, the flimsy board was also something to laugh at. To think, it's actually something they advertize. "(6 or 7?) mm New Zealand pine MDF" Huh??? There are 25.4 mm/inch, and most audiophiles consider 3/4 inch the minimum for a shelf.

I concur with Kal's assertion that a sheet of Dynamat would be worthwhile, which the Stereophile Recommended Components caption points out. Good advice there.

I could have gotten rid of it easily for at least what I paid for it(and bought a superior rack), but I would have a hard time selling such a piece of junk to another human being. And, besides, my fiance is not an audio neurotic, she thinks it's the highest of high end, and feels it greatly complements the family room. On the plus side, it holds her TV, Jadis, SACD player, DVD player, VCR, and satellite receiver. Then again, that's what a double wide rack is supposed to do.

My experience with VantagePoint racks is on the other extreme. GREAT product. Excellent design, quality, and rigidity. Also overpriced(though much cheaper than Lovan), but isn't every rack?

had similar experience with furniture works...bought a nice rack on closeout...looked great and worked fine...until one of the legs shatterred and the wheel flew off!. thank goodness i was there when it happenned or i would have lost everything. the store, harvey electronics not only wouldnt help me but said they didnt have the number for the company because they were no longer a vendor! they would however gine me a discount on another piece. if anyone has a number for furniture works i would appreciate it.

About a year ago I bought a set of Lovan Sovereign racks because they look good. Only after I took delivery I discovered that they were poorly made, the legs were out of alignment in one or two of the shelves that I could not stack them up at all. My dealer ordered another set for me - and guess - similar alignment issue existed. Eventually he allowed me to mix-and-match the shelves until I was able to assemble a properly stacked racks. I have no problem with the wooden boards though.

Wow - a lot of vitriol with respect to Lovan racks. I admit, they are not the greatest, but at least the Sovereign model can be improved if you take certain steps.

First, replace the shelves with something custom made - the MDF shelves are garbage, and the glass shelf sounds steely (and is expensive to boot). I recommend either acrylic or corian. Alternatively, maple or other hard wood of at least one inch thickness could be used as shelf material. Next, use some constrained layer damping material between the shelf and the frame (as opposed to those circular felt/sticky pads). The frame should be filled with a combination of lead shot and sand. Finally, if you are adventurous, put a set of pro MIBs under the four feet.

Admittedly, the above changes raise the price of the racks to almost double the list price, but it works pretty well, and is still much cheaper than any of the "real" high end racks.