I have 3/2’s and had a tweeter go bad. You have to go to a Wilson dealer to get them ordered along with revised resisters. I had the dealer install the tweeter and resisters. Not a cheap repair but well worth the investment in my mind.
Looking for some Watt/Puppy 5 Advice
Hello friends. First time posting, any advice is much appreciated.
I've picked up a set of Watt/Puppy 5's, running a Threshold T3 in to an Audio Research Ref110 and after considerable room tweaking I've arrived at really lovely place with the system.
At any rate, I do have a little tweeter distortion on one speaker and am reading about people replacing the driver resistors.
My main question is: Has anyone experienced a "buzzy" tweeter as a result of a failing driver resistor? Or are the resistors pretty much working if the driver is passing audio? To be honest, I've known quite a few low freq drivers to get farty but a distorted tweeter is new to me.
I've picked up a set of Watt/Puppy 5's, running a Threshold T3 in to an Audio Research Ref110 and after considerable room tweaking I've arrived at really lovely place with the system.
At any rate, I do have a little tweeter distortion on one speaker and am reading about people replacing the driver resistors.
My main question is: Has anyone experienced a "buzzy" tweeter as a result of a failing driver resistor? Or are the resistors pretty much working if the driver is passing audio? To be honest, I've known quite a few low freq drivers to get farty but a distorted tweeter is new to me.