2. misc-audio
  3. 129928-7585

List of most important

List of most important factors setting up audio listening room

This is all I have for now suggestion thoughts or comments will be appreciated and may even revise my way of thinking to update the list later.

# 1 The room. Pick best room in house or build room. According to w.a.f? a quiet room insulated from out side noise. a 40 DB noise level or lower. The outlay of the room, The ideal triangle of speaker layout. Common sense no interference with furniture or knick knacks.

 

# 2 pick best speaker according room size and to listening taste more important low end driver size. A driver that moves to much air in a small room can’t be tamed no matter how much acoustic treatment or DSP correction. This doesn’t mean you can’t have a large speaker it means you can’t have a large bass driver that moves to much air for the room.

 

# 3 The source, get the best source you can afford or garbage in garbage out

 

# 4 EQ wizard the room get your reverb time or time delay to 15ms to 20ms

With room treatment according to your liking. Next work on your bass

Get your bass as flat as possible with bass traps for your problem areas.

Example if you have a 40 Hz bump work on that to get it down. You will never get it perfectly flat especially if you have a large DB bump it’s just not physically possible when working with frequency’s that low. Once you get that as good you can I would DSP the system in my system I like to do it from 400 Hz down. Many variables when doing this trial and error then success

 

# 5 Yes I know. Where is the components ?Well do your research to see what interfaces and is recommended With your speakers if you don’t use the exact pre or amp then see what they have in common class a, tube, solid state etc. Maybe you will find a set that interfaces better. To me pre or amps are nothing more than a tuning instrument one might have a better tonal quality , one might have a better sound stage ,one might have a better punch etc. the same goes for speaker cable and interconnects . To me the analogy is like a race car you have to spend a lot to get a little more performance or not. If the product is over rated or you implement it wrong or it just doesn’t interface.

 

# 6 fine tuning not in any order high quality 20 amp dedicated circuit supply .

Vibration, dampening, isolation or decoupling. You want to hear the music not the floor resonance or vibration into your component’s to distort the signal especially turntable.

�wq �
hemihorn

Showing 1 response by akg_ca

akg_ca's avatar
akg_ca
2,335 posts
 
No I cannot agree with the OP

The components  build quality and the audio performance of the Source and the rest of the audio system components ranks #1.

The "system" is a chain of  its various audio components,  that all have their individual strengths and warts. That is why a careful marching of these components will leadto that ethereal audio OZ with a system synergy, or a failure will predicate an expensive disappointment .

The listening arena and all it's add-ons, tweaks, and accroutiments are a distant secondary portion of the overall audio satisfaction alchemy. 

IMO and personal experiences, a superior quality build and superior performance capable system player in an average arena environment will always slay the reverse. 

Example: When you attend a large audio expo, invariably held in a large hotel or convention centre with poor to extreme poor environmental influences on the audio performance.

Regardless, the "top" audio systems  themselves at those expos  always prevail over "lesser" systems even in a common comparative crummy listening environment -- . not even close -- full stop. 
More to discover