Try putting your Tukans close to the rear wall. Going active will bring a little more base, however Tukans are not base giants.
Linn's advice about bi-amping; question
I have a Linn set-up including a Majik integrated amp, an LK85 power amp, a pair of Tukans and a pair of K400 bi-wired cables. I asked Linn about how best to bi-amp, and here was their reply:
To bi-amp Tukans remove the shorting link from the Treble/Bass terminals of the speakers. Remove the jumper from the pre out/power in jacks of the Majik. Hook interconnect cables from the pre out/power in jacks of the Majik to the LK85 input/outputs respectively. Then hook the speakers up to the amps with separate speaker wires.
It's the last part I'm not sure of. Does it mean that I will need a total of 4 pieces of K400 wire (i.e. 2 pairs), or am I saved by the fact that K400 is already bi-wired. Your advice appreciated.
Thanks.
To bi-amp Tukans remove the shorting link from the Treble/Bass terminals of the speakers. Remove the jumper from the pre out/power in jacks of the Majik. Hook interconnect cables from the pre out/power in jacks of the Majik to the LK85 input/outputs respectively. Then hook the speakers up to the amps with separate speaker wires.
It's the last part I'm not sure of. Does it mean that I will need a total of 4 pieces of K400 wire (i.e. 2 pairs), or am I saved by the fact that K400 is already bi-wired. Your advice appreciated.
Thanks.