Linn Linto and Ortofon Rondo Red


I have the Ortofon Rondo Red set on a heavily modified Rega Planar 3 (cables, weight, VTA adjuster, motor).
I'm looking for a phonostage.
A friend can bring me the good old Linn linto phonostage from the US.
It means that I cannot try the combination.

Linn Linto and Ortofon Rondo Red : Will the 2 fit ?
Both are highly praised units. If I jusge by the specs they do fit but I'm wondering if anybosy here tried this combination...

Rondo red:
Recommended load impedance 10-200 Ohm

Linn linto:
The input impedance measured 165 ohms at 1kHz

http://www.ortofon.com/products/cartridges/moving-coil/mc-rondo-series/mc-rondo-red
triskadecaphobic

Showing 1 response by larryi

I thought about waiting till tomorrow, 6-13-13 to respond, but, I will do so now, because you might be "indisposed" tomorrow.

I had a Linto a while back and liked it a lot. It has a lively and engaging sound. I used it with a Lyra Helikon. A friend has it now and has used it with several different cartridges and it seems to work well with a wide variety of cartridges.

While a fixed load may make it seem less flexible than other phonostages, the chosen value should work well with most cartridges. I tend to not like cartridges loaded down excessively (i.e., LOWER resistance value, such as 50 ohms) so anything above 120 ohms or so would work for me with most cartridges.