2. tech-talk
  3. 1303492434

Likely culprit for harshness at higher volumes?

Hi,

I'm a newbie to higher end audio. I have a very modest system:
1) Pre-amp: Anthem AVM2
2) Amp: Adcom GFA-5400
3) Source: Sony CDP-X111ES CD player
4) Speakers: KEF C75
5) Toslink between source and pre-amp; cheap RCA cables from pre-amp to amp; 16 or 18 gauge speaker wire (Radio Shack?)

Room setup (10-ish feet x 20-ish feet rectangle):
1) 2 foot deep cabinets along one wall (20-ish foot)
2) Components stacked on top of small end table against rear wall (10 foot); centered between cabinets and opposite wall.
3) Speakers slightly in front of end table and about 2 feet from side walls and 4 feet from rear wall

Sounds good at about -45 to -25db; but higher frequencies get harsh at higher than -25db.

Appreciate your thoughts.
saru

Showing 1 response by 6550c

6550c
393 posts
 
My best guess is it is the CD player and maybe amp. I doubt it is the speakers or room. Higher order harmonics are not genrrated by the room. You can take steps to improve room acoustics, but that is more like icing on the cake and no way to fix bad equipment. When i first started with CD, my first impresion on 90% of CDs was things were way too harsh at even moderate volume levels . I found the only real way to improve things was to get CD players with way better digital filters and analog stages. I made the natural progerssion with better players and noticed a big improvement with each step. I went from Pioneer BPC, to Theta, to Krell, to Wadia, and back to Krell. :)
you might look for any reviews on your amp to see how it does higher order harmonic distortion. I know Adcom only really made one amp that was even close to "high end", that being the model designed by Nelson Pass. The rest of Adcom amps are strongly mid-fi and not much more than BPC. (sorry to say)
More to discover