Lead Weight on a Nuforce 9sev2

Yes Ck mapleshade triplepoint footers a maple platform sitting on isoblocks. You can see a picture at my system link. I also have installed emf material inside of the top cover of my amps, i also have ferrite rings under the amps. Enjoy the music.

I'v got my SE's sitting on top of a combination of small inner tubes with suede covered DIY sand bags on top.

Vic

Stltrains,

Are you using anything under the amps for isolation?

Ck i'm using mapleshades heavy hat triplepoints on top of my V2s. I was using JPS SC 2s and they were very stiff so i know what you are talking about. The triplepoints are working very well for weight and vibrations. A fine tweak indeed for Nuforce amps IMO.

CK. I use the large Little Rock mainly because I have owned it for the last 7 years, and it fits perfectly over the two amps. I have not tried two smaller ones.

Check out Magnan's tweaks page for Nuforce amps www.magnan.com/nuforce.html lead is one of their recommended tweaks.

Yoby,

Why did you use one Little Rock instead of two? Is there a sonic benefit using only one?

I'm using a Bright Star Audio Little Rock (13x17x1 inches) that sits on top of both of my NuForce 9.02 SE V2 amps that are spaced about 1 inch apart. I also use the Bright Star Isonode feet (the large ones) under the fixed feet of the NuForce amps. They help to soften the sound without loss of detail.

This is a long-standing problem with most gear when you have rigid, thick power cords, which most of the high-end ones are. There is much debate over what material to use to mass load components and your ears will have to be the ultimate test. Some prefer brass, others sand or lead shot.

One possibility is to have Barry at Bright Star make custom little rocks for the units. This is the most expensive option, but may be one of the best performance wise.

If you do it correctly, you will significantly improve your sound. Do it the wrong way and you will kill dynamics. I tried bricks on top of some compnents and the result was awful. For some reason unknown to me, how the weight is distributed is key and maybe even more important than the material used, which itself does also affect the sound, but to a smaller extent.