lavish with the fluids - walker / loricraft


I switched over to the Walker 4 step cleaning fluids for my vinyl a few months ago. I've had good results but some surface noise etc

When I mix up a batch of enzymes I end up getting 10-15 records (both sides) where Walker suggests 5-8

I did another batch last night and I purposely added more fluid in each step. Well the results were the difference between a hovercraft and a road grader

I had been stingy with the fluid and cleaning was more an exercise in pushing things around. much easier with a little more fluid and cleaner results

my loricraft does have some issues with the string backing up, and I end up tightening the spool which goes back into used thread. doesn't always take the new thread as strongly as I'd like (any suggestions?)

anyway - I still got 11 double sided lps, cleanup was a little messier, but it was easier spreading on the vinyl
audiotomb

Showing 2 responses by dougdeacon

1. For maximum vacuum make sure all your seals are airtight. Coat each hose fitting with a thin layer of Vaseline and reinstall the tube. Do the same for the seal on the jar lid. When it gets old and dried out, replace it with a new, standard canning jar lid (drill holes for the hoses).

2. Leave the arm hanging off the back and the vacuum pump switched on between passes (not during long enzyme soaks, just while brushing the other fluids around). Letting the nozzle suck air may help keep the vacuum tube clear (untested hypothesis, but I have fewer thread-pulling issues).

3. The nozzle can get gunked up on the inside. To clean, trim the bristles on a pipe cleaner to about half normal height for a length of about 2 inches. Wet the trimmed end and it carefully, a mm at a time, into the nozzle as far as it will go. Scrub.
Jazdoc,

Now that's health care reform. Wish we all had access to your supply room.

Can we Medevac our patients suffering from S.A.D. (Suctionary Artery Disorder) to your facility for this groundbreaking treatment? Publishing in this highly regarded, peer-reviewed journal makes you the recognized leader in the field. Of course you may want to check your P.I.S.S. (Patient Information Support System) to make sure it can handle multiple or repeat patients named "Craft, Lori".

Seriously, any idea how far up the tube you had to go to clear the blockage? My pipe cleaner is too inflexible to go beyond the sharp curve in the tube. (Of course that's a likely place for a blockage, so it may be far enough.)