You have to put the power supply in an oven and SLOWLY advance the temp until the wax melts. Before you do, make sure you make a template so the female jacks in the power supply line up properly with the male plugs on the speaker itself.
KLH Model Nine, how do I depot the wax cans?
I have a pair of klh 9's and one has lower gain with some distortion in the tweeter as well. On the recommendation of David Janszen I swapped supplies and both problems follow the supply (tweeter distortion and low gain). I had also cleaned all contact assemblies on the power supply connectors and tweeters.
I want to rebuild the weak supply and looking at it I see lots of wax. I was wondering how I would depot the cans (melt out or chip out the wax). If anyone has any ideas it would be appreciated
Andy
I want to rebuild the weak supply and looking at it I see lots of wax. I was wondering how I would depot the cans (melt out or chip out the wax). If anyone has any ideas it would be appreciated
Andy