Kimber PK 10/14 Ascent Power Cord


Has anyone used both the PK 10 and 14?  If so, (assuming the same connector metals) did you notice whether the 14 was better on sources than the 10 - or whether both were basically the same? 

Also, any comments on the Rhodium vs. Gold connectors would be welcome.
maxima95

Showing 1 response by oldhvymec

Cables pretty simple heavy amp sucking gear the heavier cable (10), lighter gear, like SACD or DAC or Preamps a 14 or 16. Personally I like weaves 16 to 24 conductor.. VERY quiet very dynamic cables.

Terminal ends.

Gold clad over copper, but never rhodium. Make sure they are not made of brass or just about anything under the sun, THEN electroplate it with very thin gold or rhodium (way to hard)

As for the best terminal material;

1. 5-7n .99+ pure(r) silver
2. red copper with silver clad
3. silver or copper with gold plate
4. red copper, or yellow copper
5. nickel over copper/red/yellow
6. anything
7. rhodium (WAY TO HARD) under water in Alaska. Good place for rhodium.

Regards