Just got the PS Audio Perfectwav DAC -- Amazing


For the last year my system has consisted of the Slim Devices Transporter (Transport + DAC) -> Bel Canto Ref1000 -> Anthony Gallo Ref 3.1

I listen to all my music digitally (lossless/flac). I was very happy with my original system but when the Perfectwave DAC came out I was intrigued. For quite a while I debated between the PW and keeping the transporter or modding it via Modwright.

I ended up getting the PW and though I can't compare it to a modded transporter, it blows the stock transporter out of the water. I should note that since the network bridge isnt out for the PW, I am currently streaming music via the transporter -> coaxial out (spdif) -> PW.

I have only listened for ~5 hours so far, but things I have noticed right away is much cleaner/tighter bass. The low end is so much more accurate than it was before. When comparing, the transporter sounded very muddy (even though at the time I though it was quite good). The mids and highs are tighter as well. The separation has improved quite a bit as well. I have immediately noticed that the loudness of different instruments is wider spread than listening to the same songs on the transporter.

Hope this helps! If anyone has any questions about the PW or the transporter I will try my best to answer them.
danyal711
of the two digital sources, which is more foregiving of poor quality cds ? also, which is the more forward of the two ?

while i may be mininterpreting your original comments, it would seem that the transporter is more colored in a pleasant way than the PWD. what is the interface between dac and transport ?
Ricky64 -- I don't have a preamp. My preamp was the Transporter and is now the PW.

Shadorne -- 1) That could be possible. The XLR of the PW does 6Vrms vs. Transporter 3Vrms. 2) The Transporter / PW controls the volume. So far havent had any problems with it and both have taken a lot of steps to make their software volume processing really good. Not too worried about that. I am trying to avoid a preamp at all costs. I am a fan of keeping the signal path as minimal as possible.
From what you say it seems the PW might be a better match to your amp.

1) Perhaps it has a better output stage than the Transporter and you are getting more dynamics?
2) If you are not using a preamp then how were you controlling the Volume with each setup? Software and digital colume control can be a bit of a minefield. The rule of thumb is to set software to MAX volume (with no processing) and to use analog controls to attenuate the sound - this helps ensures bit transparency.

Enjoy!
Hi,

Can you tell me about the rest of your system?
Have you tried bypassing your preamp.

Thanks