2. cables
  3. 167328-140010

Jumper wires/ cable suggestions

Hello Everyone,


I'm going to be setting up two McIntosh MC275s (model V) in parallel mode to drive a set of Vandersteen Quatros. I wanted to know what MC275 owners are using/ have used as their jumper wire/ cables with setting up the amps in a parallel application along with their experiences with doing so. Is choosing a higher quality jumper wire/ cable important or is this an area where it's not as important? If possible, what jumpers should I consider/ look into?

Any experiences or tips with running a set of MC275s in parallel is also welcome.

Thank you.

~Patrick


s4patrick

Showing 1 response by s4patrick

s4patrick OP
57 posts
 
Hi Everyone,

Thank you for the replies/ information.

The setup for running these amp in a "bridged" or correctly referenced for the MC275 is parallel, you need to utilize jumper connections between to output lug/ terminals. 

The parallel setup connection can be seen here:
https://www.audiogon.com/listings/lisa4f70-mcintosh-mc275-vi-tube

I'm looking for a set up jumpers like the ones within that picture.  (I believe the ones int he picture are by Furtech).  For the ones I nee, they would to have a spade-to-spade termination. 

Thoughts/ suggestions?

Thank you.
More to discover