2. amps-preamps
  3. 1389886593

Jeff Rowland Synergy's sorbothane feet.

I finally bought a wonderful Jeff Rowland Synergy 1 preamplifier to drive my JRDG Model One, but the eight sorbothane feet included in the box are not the small classical sorbothane disks shown in the Synergy's manual. They are small cylinder (upper four) or half-sphere (lower four) shaped sorbothane feet, and the seller told me that they were sometimes used by JRDG at the time he bought the preamplifier.

I tested other various feet types and I verified that the Synergy's performance is extremely sensitive to them.

May someone suggest me the best feet for the Synergy? May someone please suggest me where I can buy the original feet at a cheeper price respect to the 106 Euros requested me by the JRDG italian importer?

Thank you very much for your help!

Regards.

Luca
luca58

Showing 4 responses by guidocorona

guidocorona
4,298 posts
 
Luca, glad you received a response directly from Rowland support. It is my understanding that compliant Sorbotane footers are no longer stocked, because of possible long term structural deterioration. Have you considered looking into third party non-compliant footers... E.g. Nordost Sort Kones, or various StillPoints?

Saluti, G.
guidocorona
4,298 posts
 
Buon giorno Luca, I will contact the factory tomorrow.... Will ask them why they switched footers on Synergy... And what the best alternative might be.

Cari saluti, Guido
guidocorona
4,298 posts
 
Ciao Luca, glad you could source compliant pads... the factory must have had some remanents from old stock. They no longer use sorbotane pads for current products. The last product I have seen shipped with sorbotane pads was the M312 Since then, for heavier amplifiers they utilize bolt-on Delrin balls. Not sure what material is now being used under lighter devices like preamps.

Saluti, Guido
guidocorona
4,298 posts
 
Hi Luca, what power cord and interconnects are you using on your Sinergy?

G.
More to discover