Roger, There are two parameters you have to adjust. They are overhang, which you adjust by sliding the cartridge back and forth in the slots in the head shell and offset angle which you adjust by twisting the cartridge in the horizontal plane. Using a combination of the two going back and forth between the two points you should be able to get it right. Defeat the anti skate and it will be easier to keep the stylus right on the cross. In pictures A the stylus is probably not on the target cross. In picture B you need to push the cartridge a little farther out (increase overhang) and give it a little twist counter clock wise. Then check it at point A again.
Is this Cartridge Alignment good?
Hi all,
I just got a new MP-110 and have aligned it. Im using a RB110 tonearm for rega planar 1
I used elvon alignment for 9" arms
Theres 2 points on the alignment protractor, A and B. A is the outside alignment and B is in the inner grooves.
for point A it aligns perfectly and if I were to move it, it would not align perfect but for point B it does not align perfect, can I get any suggestions for why it would align for point A but not for point B?
I have provided pictures
Any help is appreciated, thank you
https://imgur.com/gallery/9GoB03p
I just got a new MP-110 and have aligned it. Im using a RB110 tonearm for rega planar 1
I used elvon alignment for 9" arms
Theres 2 points on the alignment protractor, A and B. A is the outside alignment and B is in the inner grooves.
for point A it aligns perfectly and if I were to move it, it would not align perfect but for point B it does not align perfect, can I get any suggestions for why it would align for point A but not for point B?
I have provided pictures
Any help is appreciated, thank you
https://imgur.com/gallery/9GoB03p