Is my anti-skating too strong.


I’m trying to adjust the alignment of the Ortofon Black Quintet cartridge on my Music Hall mmf 9.3 turntable.  When I put the stylus down on the alignment protractor, the tone arm pulls to the outer edge of the turntable.   Should I disable anti skating when doing alignment or is it set too strong?  Obviously haven’t done this too often.
Also, when listening to the anti skating track on The Ultimate Analogue Test LP, there is noticeable distortion at the end of the track which indicates too much or too little anti skating.  Any guidance here?
udog
There he is in all his glory. Chuck Miller making the reader feel small and insignificant as he pontificates his supreme and omnipotent expertise.
Go to ZuAudio and follow their procedures and you will be amazed I know I was and I'm going on 76 and have finally learned how to set up an arm to Perfection. In all my time this company is the only one that nails it as most will try to get you to buy expensive Crap don't fall for that. All you need is a blank Record that costs 30 bucks.The so called Gurus are mostly from what I've found are flat out Wrong. ZuAudio makes a souped up Denon 103 which has been my favorite since the 80's. It also was the late Great Art Dudley's favorite also.
The best way to set up is use the advice from ZuAudio as I have been into Audio Since the 60's. They have info on their site and I have to tell you it really works great. I was fed misinformation for a long time but this company nails it the improvement is astounding. For Anti Skate you first must get a blank record around 30 bucks. after you do all the recommended procedures set the arm in the middle of where your grooves would be and when it neither goes in or out you will have perfect alignment and also of great importance is getting your Vertical Tracking Alignment as to make it Orthogonally correct.
@lewm, I discussed the problem with my brother the mad scientist (MIT PhD) When you play a blank record the stylus leaves a visible scratch mark in it's path. The pressure on the very tip of the stylus is so high that it is actually digging into the vinyl so the friction equation no longer applies. It would be more appropriate to call it "drag" on the stylus which would have to be measured in order to compare it to the frictional pull on the stylus under normal conditions. The "drag" on the stylus is obviously higher since it requires more antiskating force to hold the tonearm steady.