I suggest skipping the expensive romex and using a Topaz isolation transformer, preferably one that is at least 1000 watts or higher. These are common on Ebay for $250-$300.
I got great results by doing the following:
1. If the Topaz isolation transformer is 220V in/out capable, run a heavy gauge wire, 10-2 or 8-2 from the main panel to the Topaz and use the same gauge from the Topaz to a small subpanel...8 circuits or less. From the subpanel, run your separate dedicated standard 12-2 romex runs for each circuit.
2. If the Topaz is 110V out only, skip the subpanel and run the romex for the circuits directly from the Topaz
Doing the above reduced noise/hash in the mids to the point that my system went from sounding like very good detailed revealing hifi to producing a musical experience that was just enveloping.
Your mileage may vary.
I got great results by doing the following:
1. If the Topaz isolation transformer is 220V in/out capable, run a heavy gauge wire, 10-2 or 8-2 from the main panel to the Topaz and use the same gauge from the Topaz to a small subpanel...8 circuits or less. From the subpanel, run your separate dedicated standard 12-2 romex runs for each circuit.
2. If the Topaz is 110V out only, skip the subpanel and run the romex for the circuits directly from the Topaz
Doing the above reduced noise/hash in the mids to the point that my system went from sounding like very good detailed revealing hifi to producing a musical experience that was just enveloping.
Your mileage may vary.