2. analog
  3. 1220818826

Installing a VPI stainless steel ring?

Frustrating to pay $600 and not get one lousy sheet of paper that explains how the thing works.

I expected that it gets intalled directly on the platter and has some sort of locking mechanism that you employ every time you put a new record on.... but apparently I'm wrong. Doesn't seem to sit on the platter very well at all.

Do you actually lower this thing on TOP of an LP?? I'm guessing yes, but would like the peace of mind of knowing for sure before I try it ....

Thanks again. I must have asked 20 noob questions over the past month....
madfloyd

Showing 1 response by tfkaudio

tfkaudio
591 posts
 
Yes, you put an LP on the platter first, and then you lower the ring clamp onto the platter. The clamp will sit on the outer edge of the LP, causing it to be pressed flat.

I'm not sure what the rubber belts are for. Probably a damping mechanism for the ring clamp. I can't understand why they are falling off. You are putting them into the grooves on the outer perimeter of the clamp, correct? One in place, they should not come off easily.

Tom
More to discover