If you know how to use an ohm meter you will find the crack, it will be fine because you can't see it you say, and just a blob of that conductive paint across the crack should fix them nicely.
Cheers George
Infinity Renaissance 90 Piano Black
Doubt those Monsoons will be the same quality or be a slip in replacement especially what Infinity did to the xover to make the Emim work to their satisfaction, that’s not a simple xover. https://ibb.co/tJdT1bW Did you dismantle the Emim to see where the voice coil break is, as I outlined, to be fixed with conductive demister paint?? Could even be a dry solder joint on the spade connector lug to the start of the voice coil. https://i.ebayimg.com/images/g/lXsAAOSw7~9gltvL/s-l1600.jpg Look at the voice coil difference to the Monsoon, they will be far higher VC impedance than the Emim so the xover will be out all over the place. http://i.imgur.com/oYvBh8A.jpg?1 Cheers George |
I agree with sunshdw it has enough wattage at 200w into 8ohm, but they don’t really muscle it into 4ohms only adding another 100w, the 2ohm figure would be a bit worse again and blew it’s fuses when ask to do it. And the Ren 90’s hits 2ohms EPDR and lower from what I’ve been told by a tester of them. They’d like a more Krell early amps of 200w or 300watters, which have more low impedance balls than the Adcom Cheers George |
proos Very nice speaker BTW needs an amp with massive current to get the best out of, if not it could be the reason your Emin voice coil went open circuit, because the amp clipped? If your up to it they are quite easy to replace the diaphragm on, or there’s a complete one for much more money. https://www.ebay.com.au/sch/i.html?_from=R40&_trksid=p2380057.m570.l1313&_nkw=Infinity+EMIM+... It is possible to fix them, if just open circuited with small crack with this stuff, https://www.repco.com.au/en/safety-workshop-consumables/adhesives-fillers-sealants/sealants/permatex... https://i.ebayimg.com/images/g/lXsAAOSw7~9gltvL/s-l1600.jpg Cheers George |