2. amps-preamps
  3. 185934-184419

I want to connect the NAD M10 V2 to my Marantz SR8015

Hi.. i currently have a 7.1.4 set up with the Marantz SR8015 and the Bowers and Wilkins 702 S3 and the HTM71 S3 Center channel and the M1 surrounds and Height speakers.  I want to use the pre out of the Marantz to connect the NAD M10 V2 so i can have the best of both worlds…Is this possible?  I appreciate any response.

128x128rudyc
imhififan's avatar
imhififan
2,181 posts
 

Yes, You can connect the pre out of Marantz to NAD M10 V2 "ANALOG IN 1 or 2". Connect the front left and right speakers to the NAD.

  1. Turn up the volume level of the NAD to 27dB (in order to obtain 100W max. output power), or to be on the safe side you can set it to a lower level (i.e. 20dB), but max. output power will be reduced.
  2. Re-calibrate Marantz channel levels using a sound calibration mic via Audyssey Auto setup.
  3. When you play any source through Marantz, just set the volume on the NAD to be the same as the calibration volume level. Use the Marantz to change volume and other adjustments.
  4. Always remember to lower the volume on the NAD to normal listening level when you’re not using the Marantz!

You also can use an amplifier selector to do the job.

https://www.amazon.com/dp/B093GSS8P7

 

rudyc's avatar
rudyc OP
6 posts
 

Thank you very much

rudyc's avatar
rudyc OP
6 posts
 

I ended up using the Douk VU3 and it is working well to go between music (NAD) and home theater (Marantz)…

More to discover