Try to put your tt to onother wall socket , try separating it from Sony.
Hum in speakers
Hello all
I am trying to set up a modest audio system and cant figure out why there is a hum when I turn the volume up past 55. It only happens when there is vinyl spinning. If I turn volume up without vinyl on there is no hum. Below 55 volume the hum is not there.
note: I did set the speaker impendence to 6 ohm via the receiver settings.
Set up is:
- Sony STRDH190 2-ch stereo Receiver
- Warfedale Denton 80 Speakers (16 g speaker wire)
- Technics SL-1500C Turntable
- ...
- 35 posts total
Thanks @jayctoy |
I would try a different circuit breaker when you change the plug for the TT, not just another outlet. Is it possible to turn the plug in the wall socket, sometimes changing the polarity will help (I have older TT's, always the first thing I try)? If the plug is "keyed", one wide one narrow blade you will not be able to do so. At the hardware store you can buy an inexpensive outlet tester (everyone should have one), it will look like an extension cord end. It will have LEDs on the back and the combination of the lights will tell if the wiring is correct, polarity, ground, etc. You probably are hearing 60 cycle hum, which is the frequency of A-C power. One outlet or lamp wired incorrectly, motor loads, nearby un-shielded transformers, bad ground or voltage on the neutral.....BTW some MM cartridges are "sensitive" do you have another to try? good luck |
The plug is keyed. I do have an outlet tester. I live in a pre war building so the wiring is most certainly off. I was thinking of just getting my electrician to run a new line just for my system as the wall where the system is against has no outlet and I'm plugging it all into an extension cord and power strip. Before I do that I'm thinking I will purchase a new Technics SL-1500C Turntable as this one is used. It might be worth the money as this one could be faulty. I think this is the way to go (?) |
- 35 posts total