Thermally conductive is different to electrically conductive🤦♂️
How to repair bottom diaphragm connection of Eminent Technology LFT8 planar speakers
The bottom of the board connecting the wire block came off the printed circuit of the mid range panel diaphragm. Does anyone know how to re-connect or repair this? Can it be soldered back on? I would like to avoid having to replace the entire mid-range panel if possible just for this.
I'm not sure how to attach pictures to this post to show it, but I can send pictures to your email if needed.
I'm not sure how to attach pictures to this post to show it, but I can send pictures to your email if needed.
Showing 3 responses by georgehifi
I would like to try repairing the connection first to see if this works.Should work fine with the conductive paint as there's no movement there, different story if it was on the middle of the panel where's there lots of movement I fixed some ML ESL's with the same problem using the conductive paint worked fine never gave any trouble after that. Cheers George |
cgaudio No soldering on this, use car demister paint which is conductive to make the 3 x contacts again, then wrap some sort of stretchy tape around it all to hold it all in place. https://www.ebay.com.au/itm/164396540391?chn=ps&norover=1&mkevt=1&mkrid=705-139619-5960-... Cheers George |