How to isolate turntable from footstep shake or vibration


Even while the Oracle turnable that I use has a built-in springs suspension by design there is a low or even sub-low frequency boom every time someone walks in a room. This becomes really bad with the subwoofer’s volume set high as the low frequency footsteps make straight to subwoofer where they are amplified shaking everything around. It seems the cartridge is picking up the footsteps very efficiently as even a lightest foot down becomes audioable. What can be done to attempt to isolate the turntable from the low frequency vibrations? Interesting, that the lower the volume of the subwoofer, the less the footstep shake is evident and with the subwoofer turned off it is a barely a problem at all. 
esputnix

Showing 2 responses by rocketiii

I’ve been following this thread with interest as I’ve just changed from a (fully suspended) Avid Acutus to a Techdas Airforce V which has no suspension. The Techdas is amazing and has near CD silence between tracks and the dynamics and scale of presentation is terrific.

However, I’ve been wondering how some sort of isolation might work with the Techdas. I read a lot about the Townshed isolation platform after the comments from @millercarbon and purchased one out of curiosity.

The Townshend platform has a spring/pod at each corner and is easy to set up and level. The results are quite startling with a big improvement in the ability to separate vocalists along with improved bass. In fact there just seems to be slightly more of everything. 
I’m rather surprised at the difference this has made and I’m now wondering what sort of impact this might make under my Atmasphere OTL amp!
Hi lewm9 I have the Airforce V which has an air platter and vacuum suction to hold the record flat. This model doesn’t have the air suspension which the more expensive models have.

I have all my equipment in my office which adjoins the lounge in order to reduce the impact of vibration and remove clutter from the room.