2. speakers
  3. 1283286447

How to Hook Up 4 Dq-10 speakers

I recently acquired a 2nd set of DQ-10s to add into my system of 2 DQ-10s, 2 DQ-1Ws, DQ-LP1, 2 Tandberg Amps plenty of power), 1 Tandberg Controller. I've heard of some who use only 2 amps to do this. I don't know how to hook up my additional 2 DQ10s using only the 2 amps and the electronic crossover; can anyone guide me in this? I see in the crossover manual that it is made to hook up 4 subwoofers with it, but states therein that you need 2 amps just for the subwoofers. Any guidance would be greatly appreciated.
glam
glam OP
4 posts
 
Hi Group - just a follow up. I went a bit over the top and ended up obtaining 6 sets of DQ10s, which are being powered by 3 Tandberg amps; the 2 Dalhquist woofers are run by another amp; and to supplement the bottom end - I added 2 Klipsch powered 12" subwoofers to the system. I was able to find industrical strength metal racking at Lowe's and configured in three stacks, so essentially they are stacked three upon three (left and right). Yep it goes all the way to the ceiling, I call it my "wall of sound"; so far no neighbors have called the fuzz.
sgr's avatar
sgr
689 posts
 
Post some pictures I've gotta see this!
glam OP
4 posts
 
Trying to figure out how to post picture here. Any ideas?
tpreaves's avatar
tpreaves
2,686 posts
 
so far no neighbors have called the fuzz.

I haven't heard that term in about 40 years!!!!
sgr's avatar
sgr
689 posts
 
Pictures: you need to set up a virtual system. Go to your My Page to set up your system. Once there it will guide you as to posting and naming your system and components with pictures you can load to the website. It is pretty easy.
More to discover