How to divide up $4,500, Amp/Speakers

North Creek, using Lee Taylor cabinet work, is one option of the semi-DIY kind. Assembly is work of a few hours for reasonably handy person. Don't know if the savings would be 2/3, but value is good. John

My advise was the same as Trcnetmsncom, find the best speaker that you like and figure out the amp situation after.

You have a good front end and will need a good phono preamp too (Dont skimp).. There are lots of good used speakers in the 1500 - 2500 range.

Just my thoughts
Vandersteen 2CE, Spendor sp1/2e,B&W 801 matrix III, revel F50's

New - Magnepan 1.7, Eminent Tech LFT8b

Find a used Sim 5.3 phono preamp
Used Rogue M120 or RM200 amp or Odesey monos

and you will be set...

I understand your concerns about electrostats and otls in which case I stand by my suggestion of the TLD1 and an Almarro 318b. That's not to say the es and otl option is a better one. Just different. I think the TLD1's will be more enjoyable to listen to. They can play most music. They are far more detailed in the upper registers -- the modified raven tweeter in it is the best I've heard aside from the Acapella Plasma.

Of speakers at a similar price point, I prefer them over Audionote AN/e's (the pair I heard was a $20,000 version and it quite frankly sucked), spendors harbeths and the likes, klipsch cornwalls, various Zu speakers (far lesser than the TLD1's) and so on. I think in their price point there's nothing close to as good (the same can be said about the Almarro). And frankly the only thing superior in my opinion would require entering into the realm of super expensive compression drivers. Add a pair of TAD or JBL woofers and you're there.

My last thought would be to pickup a pair of Tannoy dual concentrics. They're very easy to live with but are a little less resolving than the Tonians, electrostats, and compression driver based systems.

I own a pair of the Tonian Labs TLD1 speakers and have heard the Merlin's numerous times. I have to say they offer up quite a different sound. The Tonian's are fast, detailed, and more transparent. Sometimes a bit in your face. When in use I use no toe-in with them. The Merlin's, while not as transparent, are smoother in comparison and IMO would be easier for most people to live with long term.

Aside from that, Wilsynet mentioned a combination of the Lightspeed attenuator and Music Reference RM-10 MkII. I also use this combination and another Audiogon member uses this same combination with Merlin speakers and loves it. The only concern wold be the output impedance on the Herron which is a tad high at 500 ohms. The Lightspeed usually likes to see an output impedance of less than 200 ohms. You could check with the manufacturer to verify that. In lieu of the Lightspeed a buffered preamp like THE TRUTH of Pass B1 would work well.