Simply check for continuity-pin to pin then ground to ground, then check pin to ground to make sure there are no shorts. What this does is establish everything is connected correctly. On my rat-shack meter there is a setting for continuity. If you hear a steady tone you have a connection. The previous poster is correct about the ohms, as it should be 0 or very close to zero.
I use a cable tester to check my work. Plug them in, turn the device on & presto! Same goes for AC cords.
I use a cable tester to check my work. Plug them in, turn the device on & presto! Same goes for AC cords.