The only way to use a Sigtech with vinyl is to to use an analog to digital converter since the Sigtech only works with a digital signal. Until next year the Sigtech unit will not accept a 96khz or 192khz digital signal but it does accept a true 24 bit word. Until there is a higher sample rate you will give up too much from a high end vinyl to live with. I own a Sigtech and wouldn't give it up but have basic room treatment to make vinyl listenable. I did a lengthy post a while back if you are really interested. The RPG software, I felt, was a good start. I also found hiring an audio engineer to do in room measurements quite helpful.
How Flat is Flat?
I have been trying to optimize speaker placement in my small, dedicated room for the past couple of weeks. I started out by calculating all the theoretical "best" positions following the advice on the Cardas Webstie, the Rule of Thirds (and fifths, and ninths) AND multiple iterations with the RPG Acoustics software. For each possible speaker/listener location, I measured Frequency Response using the Radio Shack meter and several test CD's, and conducted extended listening tests with a variety of music. Leaving questions of soundstagingf aside, I can't get very flat response regardless of where I place the speakers/seat. Response is flat (+/- 3 dB) above 100 HZ and from ~ 40-45 Hz, but plagued with problems in the 50-80 Hz range. The "dip" is in the range of 6 to 15 dB, with the worst frequency being ~ 60 Hz. I have used the SGHT Excel spreadhseet to calculate the room peaks/nodes, and there shouldn't be any nodes at this frequency at any of the seating positions I have tried. I am pretty certain it's not the speakers (SF Guarneri Homage), since they measure flat in an anechoic environment. The room is 14 ft long, by 12.75 ft wide by 7ft9inches long (dimensions chosen using the SGHT spreadsheet based on the fixed height of my basement ceiling). I have minimal sound treatment at this stage (RPG foam at the reflections points, RPG Diffusers behind the listening position, Corner Tunes at the top and bottom corners behind the speakers). My questions is...is it desirable to do better, or am I just being REALLY anal? If desirable, is it possible to do better? How (short of getting a Sigtech or similar)? Would also appreciate any comments on the best scheme for speaker positioning you've tried. Anyone have experienve with the RPG software? The Cardas-based set-ups sound good..but the bect sounding one is VERY awkward even in a dedicated room! AlexC