How do you determine how much to spend on speakers

I have never understood the relevance of the phrase "garbage in, garbage out" in these types of discussions. If a $1000 to $1500 integrated amp is producing "garbage out", then you were ripped off. The THD on a Yamaha a-s1000 integrated, which sells for around $1200 is less than 0.02%. The only thing that a more expensive amp might do is play louder. Louder, not cleaner.

The 'Garbage In Garbage Out' axiom is I believe directed towards the source componet.

Mentioned earlier you CANNOT fix, repair, replace or get back lost digital or analog data once it has been sent upstream to the next component in the signal chain. In fact the amplification that occurs in each component is an enlargement, not of the original signal, but of the signal it receives. If there is dirt, distortion, or grain, these flaws are MULTIPLIED with each enlargement. By the time the musical signal gets to the speakers these flaws have been multiplied several thousand times. This is why the source is the most important part of any system.

That signal is then converted to another format once it reaches the DAC, run through a filter and a buffer, several chips, then converted to analog where it’s run through another filter. That signal then travels in the analog domain through several thousand parts in a preamplifier and amplifier in the analog domain before being sent to the speakers.

No matter how good, how expensive, or how many claims of magic the back end components in your audio system may boast, the best signal they will ever see is what comes from your source.

As you can see from the above, there is very little hope that any system will ever deliver what was recorded to the "Master Tape" or produce what was heard in the studio.

Put your dollars into best electronics, upgrade speakers later. That way you'll always get the most out of your speakers - they can't fix a poor signal from source components and/or preamp.

The hardest and arguably the most critical is the transformation of energy. Physics here folks. Electronics is important but the electrical to acoustical and the mechanical to electrical (vinyl) is the hardest to do accurately. The speakers man.! Cartridges too. Any vinyl heads swapped cartridges and heard a small difference compared to swapped amps etc.Not me. Rule of thumb (my opinion) spend 1/3rd to 1/2 $ on the speakers..

Considering the original post was 1-16-02 , I am sure he already bought what he needed.