High amperage High-pass filter


I need an inexpensive speaker-level high-pass filter that can handle the higher amperage of a large power amp. It is for a bar that is exploding speakers. I need to set a "brick wall" at about 60Hz. Radio Shack only has the little caps that are likely to explode. I went to the local car audio shop and they had nothing that would work. I went to the local guitar shop and they had nothing that would work.

Any advice would be most appreciated.
bignerd100
What would be a good source for learning how to assemble the needed caps, inductors, etc?

Line level will not work for this particular installation.

The set-up is music server-> integrated amp-> speakers.
The speakers are on the "A" tap and the subwoofer is on the "B" tap. This way they can turn the sub off with the touch of a button for low volume (less crowded) times. The problem is that there is a huge peak in the bass of some of the music they are playing around the crossover point of the speakers which causes them to bottom out at high volume levels.

Thanks for the link!
Contact Parts Express -- they should have what you need. Here's the link:
http://www.partsexpress.com/
How about a line level EQ? What is the setup? Source - Pre amp - power amp?