2. analog
  3. 1223790209

Help with Setting Up Nottingham Spacedeck

I recently bought a used spacedeck. I have no problem setting up the table and VTF. However, the instruction of adjusting the bias (I assume it means anti-skate) is very vague. I think I am supposed to move the little hammer for adjustment. I moved it to a point where I think the sound is balanced through the LP. Is there anything else I need to pay attention to? Or what else am I supposed to listen to in order to set this up?

Most of my analogue experience came from mid-end direct drive tables so I am not so sure if I set up the Nottingham right. I'd like to get some kind advice from existing Nottingham owner. And I appreciate any general help as well. Thanks!
hklai

Showing 1 response by sbank

sbank's avatar
sbank
3,381 posts
 
A Neuance shelf underneath the table(either with or without base) makes a huge improvement!

One thing to check is the pivot-to-spindle distance. I forget what the value should be(check the manual--something like 211mm), but if it is off, you need to remove the platter then loosen a bolt that allows you to swing the tonearm pod on an arc. Move the pod on the arc until the distance from pivot-to-spindle is exact, tighten the bolt, then put the platter on and then setup your cartridge.
The sliding metal donut adjusts anti-skate. I found it didn't work well, and didn't affect sonics much. Cheers,
Spencer
More to discover