2. analog
  3. 1123244174

Help with phono cartridge loading/ARC SP6B preamp

My new Lyra Helikon has a recommended load between 100 and 47k ohm, and as I'm running it directly into my phono stage (no step up needed) I have been listening during the break in period without load. I assume my preamp is factory set at 47k ohm, do I have to remove the factory load resistors prior to installing the new load resistors (100 ohm or more)? If so, can anyone tell me where these factory installed resistors are located? A quick search of the preamp indicates they are not soldered to the RCA terminals where I plan on installing the new load resistors so they must be soldered directly to the circuit board? Can anyone with Helikon ownership experience suggest the ideal load? Thanks!
badboss429
linnlp12
79 posts
 
The 6B will not run your Helikon, you need a step up. There is a switch on the back to change from 54 to 6_ gain. But it still is not enough and the higher gain setting is very noisy. It was designed for moving magnets. The 47k is part of the design and isnt meant to be changed like in a moving coil stage.
dougdeacon
3,338 posts
 
Badboss429,

Sorry for missing the info in your thread title, duh.

At any rate, I agree with the responses above. To run a Helikon you'll either need a stepup (which would also adjust the impedance) or a phono stage designed for LOMCs.
badboss429 OP
21 posts
 
Thanks all for the feedback, here is an update: I spoke with Lenard at ARC-the preamp is factory set for 49.9k ohm, having resistors soldered onto the board. Adding resisters in parallel accross the rear of the RCA jacks is not a problem. Based on extreemly beneficial phone support from Ngarch (thanks Neil!), I experimented with various resisters ranging from 100 ohm to 225 ohm and settled on 163 ohm, providing fair deeper and tighter base and much much sound staging air and presence. As gain goes, the Helikon is doing a fine job without additional step up.
More to discover