I had this exact problem after I upgraded my TNT to a superplatter, ring clamp and SDS. In my system, it was caused by the SDS - the SDS does not provide enough start-up torque with the older SAMAs. In my case, I had a 14 year old SAMA. I changed the SDS voltage and VPI even sent a capacitor, but nothing helped. The solution was to purchase and install the VPI 300rpm motor upgrade kit. Check it out here:
http://www.elusivedisc.com/prodinfo.asp?number=HW-SCOUTM
It was very easy to do and competely took care of the issue. I run the SDS at the factory set voltage and my TNT is quiet and starts up each and every time.
Brent
http://www.elusivedisc.com/prodinfo.asp?number=HW-SCOUTM
It was very easy to do and competely took care of the issue. I run the SDS at the factory set voltage and my TNT is quiet and starts up each and every time.
Brent