I add small toggle power switches to units that don’t have them. Just like a light switch only small. Buy at local electronics store (or light fixture parts dept).
I drill small hole in faceplate. In your case, you have a hole in the faceplate, round or rectangular. remove the switch, take it with you. Take unit specs re: voltage/wattage load.
many small switches exist, drill small hole in front, or, find one that fits your faceplate hole if lucky. wire to existing switch points, or, grab incoming leg, add switch, other side of switch to where that input leg was going.
you only interrupt 1 leg, draw two parralel lines. interrupt one line with an S.
another method is bypass switch internally, and add a line cord switch, or plug into a switchable device, i.e. power from pre-amp switched outlet.
I drill small hole in faceplate. In your case, you have a hole in the faceplate, round or rectangular. remove the switch, take it with you. Take unit specs re: voltage/wattage load.
many small switches exist, drill small hole in front, or, find one that fits your faceplate hole if lucky. wire to existing switch points, or, grab incoming leg, add switch, other side of switch to where that input leg was going.
you only interrupt 1 leg, draw two parralel lines. interrupt one line with an S.
another method is bypass switch internally, and add a line cord switch, or plug into a switchable device, i.e. power from pre-amp switched outlet.