Heavy Duty Binding posts for Krell KSA 250

The Cardas ones are just beautiful, however the shaft size is larger than the stock ones and so the buss bar hole diameter would have to be increased a bit. Not that big a deal, but I was hoping that there might be something out there as nice as the Cardas yet require a little less work.

Rrog thanks for your feedback, but I If I do decide to go with the Cardas, I am not too concerned with the sound degrading as a result of using these super high quality binding posts. If anything, it may actually improve due to the increased purchase area and the use of top notch materials in the Cardas.

Response from the OP:

My..Mr. Rrog..arent we a condescending SOB! Maybe you should ask questions before making assumptions. But, oh, no that might be the prudent thing to do and if you did that you might not be able to justify your pompous rant. FYI. I did re-spade my EXISTING Cardas cables specifically for this amp, in other words, went to a smaller spade, Mr. smarty pants! If you had any experience with this amp whatsoever you would KNOW that the plastic stock posts are very basic and do not lend themselves well to some of today's heavy duty cables. But Cardas Golden Reference are amazing sounding speaker cables and I'm not about to give up on them! There may be some truth to what you say about the potential for the sound changing ( just doubtful how much and might it just be for the better) And as Mr. Rayooo says (BTW this gentlemen seems very knowledgeable about Krell amps as am I since I have had owned Krells since the late 80's) these are not difficult to change as long as you have some electromechanical expertise. Just so happens I do! The nice thing about these Krells is they have 2 sets of binding posts per channel and my plan is to change the top set and leave the bottom set in tact. And we'll just see what happens to the sound! If I don't like it, I'll go back to stock. Is that OK with you Mr Rrog?? Hmmm? Jeeesh!!