Has anyone used cones on there Dunlavys'

Snook, I modified the sc 4a,s. no not really as long as you have done soldering before. but be careful has always you take a chance but ive done this many times and the bennefit is worth it.On the binding post is i beleive 8 screws , remove them and you well probaly have to use a flat head screw driver and very carefully ease it between the panel and the speaker, work it a bit and it well pop loose. The croosx well then slide out, check out your values on each of the caps and resistors. Has far as resistors go dont stack them again add the ohm togeather and replace with the corresponding ohm.Look up www.northcreekmusic.com for values and ohm on your parts and always bypass.
If you have a little back ground in this area try it otherwise dont

Interesting Steven. Which Dunlavy's did you modify? Was this difficult to do?

havent tried cones but made a base with 3 sheets of sheet rock 1 sheet of 1/2 inch ply. then 3 sheets sheet rock. sounds great better bass and focus.also just replaced the croosover component. they use cheap sand resistors and replaced with ohmite wire wound. also the solen caps with crescendos. the sound is 10x more musical and natural would be a understatement. the tweeter i replaced with the scan speak 9500. this is what a dunlavy should sound like for 7000 plus.

My Dunlavy SC-V's are on an ak floor with full 2x10 joists spaced 12 inches apart. The floor was originally built to hold a grand piano. I crossed the joists at the centerpoint of the speakers and used a basement jack on a solid 12inch block of oak with an industrial generator damping mat below. I had an audio engineer do impulse measurements while we tightened the jack until the scope trace was the cleanest at the listening position. This made a huge improvement in the bass tightness. Then I added basic ASC tube traps and then the Sigtech DSP. The sound is awesome and FLAT to 22HZ

I have installed 3 cones each under my Vs. Original reason was that that I needed to remove the big bases that did not fit with scheme (tv,cabinets), and without cone speakers, although at 350+lbs each, would sway easily on the carpet. The cones made them stable and coupled with concrete floor below. The result is firmed up base, slightly increased focus. Although I never tried with bases on in my home from day one. I had auditioned this way at the dealer's.DUNLAVY FAN CLUB, I AM IN MAN!. For me, the speaker world ends at Dunlavy.

I have installed 3 cones each under my Vs. Original reason was that that I needed to remove the big bases that did not fit with scheme (tv,cabinets), and without cone speakers, although at 350+lbs each, would sway easily on the carpet. The cones made them stable and coupled with concrete floor below. The result is firmed up base, slightly increased focus. Although I never tried with bases on in my home from day one. I had auditioned this way at the dealer's. DUNLAVY FAN CLUB, I AM IN MAN! For me, the speaker world ends at Dunlavy.