2. amps-preamps
  3. 163261-156055

Hafler 9130 Right Input RCA loose... How do I access this?

Hello,
I purchased a 9130 and didn't realize until too late that the right channel input RCA is loose. It still plays but it pushes in when I connect a cable to it and cuts out from time to time and I have to 'jiggle' it. 

I removed the top panel and it looks like the inputs are underneath the main circuit board. It looks like there is not a bottom access panel or I just can't figure out how it comes off.

I am new here but have seen posts from a couple years ago where techs familiar with this amp were very helpful. Hoping they are still around. I'm not a technician but I can recognize the various components, etc. Any help would be greatly appreciated.

Thanks!
gerdz

Showing 1 response by gerdz

gerdz OP
1 posts
 
Thank you both for your quick and informative replies. I wasn't able to get to it until today and it looks like I (hopefully) had it all wrong. The jack itself doesn't seem to move much. I think the RCA jacks are just slightly smaller than those on other devices (worn?) and my interconnect was slightly large so I compressed the ring a skosh and all seems well. The cable fits snugly enough on new devices but was sloppy on the Hafler. Fingers crossed.

Thanks again for your time.
Mike.
More to discover