I think your Studio, not Studietto, had a more involved power supply than a wall wart for the table motor. If the Pabst motor goes bad the table is done! The arm motor may be simpiar, but it had an outboard controller. The arm was fussy about set up and will lift in the middle of the record. However they are great TTs. Connections/wiring may be tough. PH
Goldmund Studio Power Supply Help
I have in my possession an extremely early Goldmund Studio serial number 66 .
It is in the natural beech wood finish , Not the piano black lacquer version.
Anyway the table , T3 arm and dust cover are in mint condition .
It's a stunning example.
However the power supply (wal-wart) has been misplaced .
I know it is a DC power supply.
What I am hoping someone may know the answer to is.
What is the rating of that power supply . IE - voltage and amperage .
Any help here would be greatly appreciated .
It is in the natural beech wood finish , Not the piano black lacquer version.
Anyway the table , T3 arm and dust cover are in mint condition .
It's a stunning example.
However the power supply (wal-wart) has been misplaced .
I know it is a DC power supply.
What I am hoping someone may know the answer to is.
What is the rating of that power supply . IE - voltage and amperage .
Any help here would be greatly appreciated .