Goertz MI2 and amp oscillation

simply saying, your amp will be stable with these cables. Most-likely SET amp(s) will not be stable with them.

Mark, The signes of problems would be overheating and continuous shut off from your amp.However you can eliminate the oscillation by placing RC match link across the binding post on both speakers.It will not effect the sound quality.You can order it from Alpha Core free of charge.I hope this helps.

If your amp is of a wide-bandwidth design, it would probably be wise to use zobel networks with these cables. Keep in mind that an amp can become "partially unstable" and not go into continual oscillation. Severe cases will manifest themselves as an extreme amount of heat build-up, the smell of smoldering electronics, protection circuitry kicking in, etc... Then again, most wide bandwidth amps don't use protection circuitry due to the negative sonic impact that go along with such circuitry. Sean
>

Thsnks your all of your responses. My amp is running as cool as ever. I talked to Alpha Core and they said that problems occur on about 1% of amps. They assured me that they have never seen any problems with Electocompaniet. But I think I will get the Zobel's just for piece of mind.