I have the newer round amp on my 300s and if I listen to anything with serious bass it will turn off. In addition to that when I turn the bass amp on it will trip my main amp to temporarily shutdown. I think there are some serious design issues with this amp.
Genesis servo-bass amplifiers
My question is directed at owners (past or present) of the following Genesis models: 1.1, 201, 350, & 350SE.
Have any of you experienced problems with the bass amp shutting down due to transient overloads?
The bass amps included with these speakers have a protection circuit which may trip due to either a transient or thermal overload. Each failure mode is described below:
Transient Overload:
- Amplifier runs cool to warm to the touch but protection circuit trips excessively
- Often occurs with electronic music (e.g. rap/hip hop) on particular tracks only
- Amp will immediately turn back on but may trip again moments later
- Minor reductions in volume (-3dB) typically have no effect (amp will still trip)
Thermal Overload:
- Amplifier runs hot to the touch during heavy use and protection circuit trips
- Amp will not turn back on until it cools down (may take up to 30 minutes)
I'm wondering if anyone else has experienced the transient overload case, and if they've found a way to eliminate it.
I understand that the thermal overload case means the amplifier is at maximum power, and the only way to fix it is to turn the volume down.