2. misc-audio
  3. 141463-4014

Experiment: Level Matching Frequencies

For fun, from my listening position, I experimented with a Radio Shack SPL meter and a demo disc. Using the ROON equalizer, I level matched frequencies at 80dB (50Hz, 63Hz, 80Hz, 100Hz, 125Hz…etc.) This took a few hours and the results were not good.

Of interest, I corrected a peak of +12dB @ 80Hz, a dip of -8dB @ 100Hz,  and a peak of +6dB between 160-200Hz. Other frequencies up to 10kHz needed minor adjustment of +/- 1 to 3dB.

With adjustments, music sounded terrible. For example it was very thin in the mids, compared to no EQ. This experiment was a waste; I expected and hoped these adjustments would improve the sound. Please note: I am a recreational listener, not and EE nor majored in music which means this experiment was ad hoc and  unscientific.

Have any of you tried this or have thoughts as to why level matching frequencies this way had poor results?

128x1284hannons

Showing 2 responses by 4hannons

4hannons's avatar
4hannons OP
187 posts
 

Thank you, Bob.

IIRC the EQ function of ROON has received praise for not harming the signal. The more I think about it the more this experiment may become a laypersons journey into optimizing the ROON equalizer.

Can any other  ROON users chime in? Or anyone with experience in EQ? Perhaps this will morph into a  discussion of tips, successes and failures using the EQ function of ROON.

4hannons's avatar
4hannons OP
187 posts
 

Thanks Elizabeth, forgot to mention that I adjusted the Q as necessary, for example the peak at 80Hz and at 100Hz both had a Q of 1 (very thin slope), the Q at 160-200Hz had a Q of 6 (or 8?) at 185Hz to cover the range.

Quite possible I didn’t have tight enough Q; perhaps I should have used 0.5 Q in the above examples.

Your suggestion of boosting around the peaks might have merit, it’s certainly something I’ll give some thought.

More to discover